D-Link xStack DGS-3120 Series Cli Reference Manual page 781

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3120-24TC:admin#config power_saving hibernation add time_range range_1
Command: config power_saving hibernation add time_range range_1
Success.
DGS-3120-24TC:admin#
78-3 config power_saving led
Description
This command is used to add or delete the power saving schedule on the LED of all ports. When
any schedule is up, all port's LED will be turned off even device's LED working on PoE mode.
NOTE: The port LED admin state (configured using the command 'config led state') gets high
priority. If the port LED admin state is disabled, all ports' LED will always be turned off.
Currently only three time ranges are supported.
Format
config power_saving led [[add | delete] time_range <range_name 32> | clear_time_range]
Parameters
add - Specify to add a time range.
delete - Specify to delete a time range.
time_range - Specify the name of the time range.
<range_name32> - Enter a name for maximum 32 characters.
clear_time_range - Specify to clear all the time range of port LED.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a time range named "range_1" on port LED:
DGS-3120-24TC:admin#config power_saving led add time_range range_1
Command: config power_saving led add time_range range_1
Success.
DGS-3120-24TC:admin#
78-4 config power_saving port
Description
This command is used to add or delete the power saving schedule on the port. When any
schedule is up, the specific port will be shut down (disabled).
NOTE: The port's admin state has high priority. If the port's admin state is disabled, the specific
port will always be shut down (disabled). Currently only three time ranges are supported.
776