Chapter 17 Configuration Command List; Show Config - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 17 Configuration Command
show config [effective | modified | current_config | boot_up | information| file <pathname>]
{[include | exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include |
exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude |
begin] <filter_string80> {<filter_string 80> {<filter_string 80>}}}}}
config configuration {unit <unit_id>} <pathname> [boot_up | active]
save {[config <pathname> | log | all]}
show boot_file
17-1

show config

Description
This command is used to display the content of the current configuration, the configuration to be
used in next boot, or the configuration file specified by the command.
The output stream of the configuration data can be filtered by the expression specified at the end
of the command. The expression can contain up to three multiple filter evaluations. A filter
evaluation begins with a filter type (include, exclude, and begin), followed by up to three filter
strings (ex: "stp"). A filter string is enclosed by symbol ". The following describes the meaning of
the each filter type.
include: includes lines that contain the specified filter string.
exclude: excludes lines that contain the specified filter string
begin: The first line that contains the specified filter string will be the first line of the output.
The relationship of multiple filter strings following the same filter type is OR. That is, one line is
qualified if one of specified filter strings is matched.
If more than one filter evaluation is specified; the output of filtered by the former evaluation will be
used as the input of the latter evaluation.
Format
show config [effective | modified | current_config | boot_up | information| file <pathname>]
{[include | exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include
| exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include |
exclude | begin] <filter_string80> {<filter_string 80> {<filter_string 80>}}}}}
Parameters
effective - Show only commands which affects the behavior of the device. For example, if STP is
disabled, then for STP configuration, only "STP is disabled" is displayed. All other lower level
List
193