Chapter 18 Configuration Trap Command List - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 18 Configuration Trap
config configuration trap {save [enable | disable] | upload [enable | disable] | download [enable |
disable]}
18-1 config configuration trap
Description
This command is used to configure the trap status of configuration saving completed, configuration
uploading completed and configuration downloading completed.When set to enabled, the SNMP
Agent will send a trap while the related operation (save / upload / download the configuration) is
successfully completed.
Format
config configuration trap {save [enable | disable] | upload [enable | disable] | download
[enable | disable]}
Parameters
save - (Optional) Enable or disable sending the trap by the SNMP agent when the configuration
is saved in NVRAM.
enable - Send the trap by the SNMP agent when the configuration is saved in NVRAM.
disable - No trap will be send.
upload - (Optional) Enable or disable sending the trap by the SNMP agent when successfully
uploading configuration.
enable - Send the trap by the SNMP agent when successfully uploading configuration.
disable - No trap will be send.
download - (Optional) Enable or disable sending the trap by the SNMP agent when successfully
downloading configuration.
enable - Send the trap by the SNMP agent when successfully downloading configuration.
disable - No trap will be send.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the trap of a configuration saving completed:
DGS-3120-24TC:admin#config configuration trap save enable
Command: config configuration trap save enable
Success.
DGS-3120-24TC:admin#
Command List
198