D-Link xStack DGS-3120 Series Cli Reference Manual page 262

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to a console:
DGS-3120-24TC:admin#debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
DGS-3120-24TC:admin#
22-18 debug dhcpv6_relay packet
Description
This command is used to enable or disable the debug information flag of the DHCPv6 relay packet,
including packets receiving and sending.
Format
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specify the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 relay packet sending debug:
DGS-3120-24TC:admin#debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
DGS-3120-24TC:admin#
257