Chapter 33 D-Link Unidirectional Link Detection (Duld) Command List (Ri And Ei Mode Only) - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 33 D-Link Unidirectional Link
config duld ports [<portlist> | all ] {state [enable | disable] | mode [shutdown | normal] |
discovery_time <sec 5-65535>}(1)
show duld ports {<portlist>}
33-1 config duld ports
Description
The command is used to configure unidirectional link detection on ports. Unidirectional link
detection provides discovery mechanism based on 802.3ah to discovery its neighbor. If the OAM
discovery can complete in configured discovery time, it concludes the link is bidirectional.
Otherwise, it starts detecting task to detect the link status.
Format
config duld ports [<portlist> | all ] {state [enable | disable] | mode [shutdown | normal] |
discovery_time <sec 5-65535>}(1)
Parameters
<portlist> - Specify a range of ports.
all - Specify to select all ports.
state - Specify these ports unidirectional link detection status.
enable - Enable unidirectional link detection status.
disable - Disable unidirectional link detection status.
mode - Specify the mode when detecting unidirectional link.
shutdown - If any unidirectional link is detected, disable the port and log an event.
normal - Only log an event when a unidirectional link is detected.
discovery_time - Specify these ports neighbor discovery time. If OAM discovery cannot
complete in the discovery time, the unidirectional link detection will start.
<sec 5-65535> - Enter a time in second. The default discovery time is 5 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable unidirectional link detection on port 1:
Detection (DULD) Command
List (RI and EI Mode Only)
382