Installing The Control Panel - Response SL3 Installation And Operating Manual

mounted. The Control Panel should be mounted
at a convenient height of between 1.5 and
2 metres and in a position where it will be
seen each day.
Note: If small children are in the household, a
further consideration should be given to keeping
the unit out of their reach.
3. It is recommended that the Control Panel should
be positioned such that the Exit/Entry tone
(emitted by the Control Panel) can be heard from
outside the property.
4. The Control Panel should be mounted within a
protected area so that any intruder cannot reach
the Control Panel without opening a protected
door or passing through an area protected by a
PIR Detector when the system is armed.
5. The Control Panel must be located within
reach of a mains socket.
6. DO NOT fix the Control Panel onto or very
close to metalwork (i.e. radiators, water
pipes, etc) as this could affect the radio
range of the device.
External Tamper
Switch Jumper
Link P51
Upper Keyhole
Fixing Hole
+ ve Terminal
(Red Lead)
– ve Terminal
(Black Lead)
Lower Fixing
Hole

INSTALLING THE CONTROL PANEL

1.
2.
3.
4.
Inside View of Control Panel
Undo the two cover fixing screws on top of the
panel and open the cover. The cover is hinged
along the bottom edge.
Unclip and remove the two back-up batteries on
either side of the panel.
Hold the Control Panel in position on the wall
and mark the positions of the four fixing holes.
Remove the panel, drill four 5mm holes and fit
the 22mm wall plugs.
Note: The wall plugs supplied with the product
are not suitable for plasterboard walls. If
mounting the Control Panel onto plasterboard
use appropriate wall plugs.
Do not drill the fixing holes with the Control
Panel in position; as the resulting dust and
vibration may damage the Control Panel's
internal components and invalidate the
guarantee.
Fit two 18mm No.4 screws into the top holes until
3mm protrudes from the wall face and hang the
Upper Keyhole
Fixing Hole
– ve Terminal
(Black Lead)
+ ve Terminal
(Red Lead)
Power Supply
Cable Access
Hole
Reset Jumper
Link P1
Power Supply
Jack Socket
9