Response SL3 Installation And Operating Manual page 7

C
C
LOUNGE
C
protection. However, the following rules should be
followed:
a. Any detectors covering the main door and the
route to the Control Panel should be set on
zone 1 only.
b. Any detectors covering the remainder of the lower
floor should be set on zones 2 to 4 only.
c. Any detectors placed upstairs should be set on
zones 5 or 6 only.
The pre-configured system defaults provide a basic
functional system which will suit most installations,
(i.e. a 2 floor house.
The systems factory settings are pre-configured to
provide a basic functional system to suit most typical
basic installations:
The system has a 3 minute alarm duration.
The Zone Lockout feature is ON so that if any
single zone triggers an alarm more than 3 times,
A
D
B
D
Back Door
KITCHEN
HALL
A D
GROUND FLOOR
E
C
D
SHED
C
DINING
ROOM
GARAGE
alarm signals from that zone will be ignored until
the system is next re-armed.
Detectors on Zone 1 (typically the front door
and hallway) will have a 30 second entry/exit
delay period.
Detectors on all other zones are configured as
INSTANT, (i.e. they have no entry/exit delay).
Part-Arm is configured to operate with detectors
on zones 1 to 4 only.
Note: If you wish to change the system configuration
away from the above example and factory settings
and customise it to your own unique requirements or
activate any of the more advanced system features
then refer to the Programming section on page 26.
This manual also covers installation and operation
for accessories, which may not be supplied with this
alarm kit. When purchasing accessories, please
refer to the manual supplied with the accessories for
further information on these items.
A
B
D
C
D
D
D
E
ZONE 1 ZONE 2 ZONE 3 ZONE 4
ZONE 5 ZONE 6 FIRE TAMPER
POWER PART ARM ARM LOW BATT.
1 2 3
4 5 6
!
7 8 9
ESC
0
ENTER
Control Panel
Remote
Control
PIR Movement
Detector
Magnetic
Door/Window
Detector
External
Solar Siren
7