Table of Contents
Advertisement
The Keypad is powered by a PP3 Alkaline battery
which under normal conditions will have an expected
life of approximately 1 year. When the battery level
drops, the "LOW BATT" LED on the front of the
Keypad will flash. When this occurs the battery
should be replaced as soon as possible.
Transmit
Low Battery
Indicator LED
Indicator LED
0
1
2
4
5
7
8
When using the Keypad the buttons must be pressed
firmly and within five seconds of each other. If you
make a mistake, wait ten seconds and start again.
When a button is pressed the
The Keypad has a back light which illuminates the
buttons for 5 seconds when the cover is first opened
or for 5 seconds after any key is pressed.
POSITIONING THE KEYPAD
The Keypad is suitable for mounting in dry interior
locations only.
The Keypad should be located within a protected
area so that it cannot be reached by an intruder
without opening a protected door or passing through
an area protected by a PIR Movement Detector.
The Keypad should be mounted in a position close to
the main entrance door so that the User Access
Code can be entered and the alarm system shut
down within the 15 seconds entry time period.
Note: DO NOT fix the Keypad onto or very close to
metalwork (e.g. radiators, water pipes, etc) as this
could affect the radio range of the device.
INSTALLING AND CONFIGURING
THE KEYPAD
Note: If adding a Keypad to an installed system,
ensure that the Siren is in Service Mode before
commencing installation, (see page 19). Remember
to switch the Siren back to Operating Mode after
8
Button Press
Indicator LED
Instant-Arm
Disarm
3
Delay-Arm 1
6
1
9
2
Delay-Arm 2
LED will illuminate.
installation is complete, (see page 19). If the Siren
Unit is being installed and configured for the first
time refer to pages 10 - 12.
1.
Undo and remove the fixing screw from the
bottom edge of the Keypad and remove the wall
mounting plate.
2.
Using the mounting plate as a template, mark
the positions of the four fixing holes on the wall.
A small spirit level will ensure it is perfectly level.
3.
Fix the mounting plate to the wall using the four
18mm No.4 screws and 22mm wall plugs as
required, (a 5mm hole will be required for the
wall plugs). Do not over-tighten the screws as
this may distort or damage the mounting plate.
4.
Undo and remove the two fixing screws securing
the rear battery cover and remove the cover.
5.
If the battery has already been installed then
remove it.
6.
Press and hold any key for more than 1 second.
7.
Set the jumper link J1 as shown in Fig. 1b:
3
1
Fig. 1a
Wall Fixing
Plate
Fixing Screw
Jumper Link J1
3
1
Fig. 1b
Hide quick links:
Advertisement
Table of Contents
