Table of Contents
Advertisement
Control Panel
Positioning the Control Panel
When choosing a suitable location for the Control
Panel, the following points should be considered.
1. The Control Panel should be located in a position
out of sight of potential intruders and in a safe
location, but easily accessible for system operation.
2. The Control Panel should be mounted on a sound
flat surface to ensure that the rear tamper switch
on the Control Panel is closed when the Panel is
mounted. The Control Panel should be mounted
at a convenient height of between 1.5 and 2m and
in a position where it will be seen each day.
Note: If small children are in the household, a
further consideration should be given to keeping
the units out of their reach.
3. It is recommended that the Control Panel should
be positioned such that the Exit/Entry tone
(emitted by the Control Panel) can be heard from
outside the property.
4. The Control Panel should be mounted within a
protected area so that any intruder cannot reach
the Control Panel without opening a protected
door or passing through an area protected by a
PIR Detector when the system is armed.
5. The Control Panel must be located within reach of
a mains socket.
1
2
3
4
ZONE
5
6
FIRE
TAMPER
1
2
3
4
5
6
7
8
9
0
ESC
External view of Control Panel
6. If the telephone voice dialler is to be used then the
7. Do not locate the Control Unit closer than 1m to
Installing the Control Panel
1. Undo the two captive fixing screws on top of the
2. Unclip and remove the two back-up batteries on
3. Hold the Control Panel in position on the wall and
7
Control Panel will need connecting to a convenient
telephone point.
any large metallic object, (e.g. mirrors, radiators,
etc) as this may affect the radio range of the
Control Panel.
panel and open the cover. The cover is hinged
along the bottom edge.
either side of the panel.
mark the positions of the four fixing holes.
Remove the Panel and drill four 5mm holes and fit
the 25mm Wall Plugs.
Note: The wall plugs supplied with the product are
not suitable for plasterboard walls, if mounting the
Control Panel onto plasterboard use proprietary
wall plugs.
Important: Do not drill the fixing holes with the
Control Panel in position; as the resulting dust and
vibration may damage the Control Panel's internal
components and invalidate the guarantee.
Zone LEDs
Status LEDs
Keypad
Advertisement
Table of Contents
