Advertisement
2.
Secure the ball and socket mount to the wall
using either the provided wall anchors or by
screwing directly into a wall stud.
installed securely on the wall, slide the insert
bracket of the mount into the back of the unit
and lock in place. The mount will click when
secured to the alarm.
INSTALLING BATTERIES
Installing batteries in the Alarm:
The Motion Sensing Alarm requires three AA
Alkaline batteries (not included).
The battery compartment is located on the back of
the unit.
1.
Remove the battery compartment screw and slide
off the cover in the direction of the open arrow.
2.
Insert three AA Alkaline batteries (not included).
Take care to note the polarity diagram inside the
battery compartment.
3.
Replace battery compartment cover and secure
screw.
Installing the
The Remote Control is supplied fitted with one
CR2032 battery. Average battery life for typical
usage is up to one year.
The battery compartment is located on the back of
the unit.
1. Slide
off the battery compartment cover located
on the back of the Remote Control.
2.
Carefully remove the battery isolation tab fitted.
Once
3.
Replace cover.
LOW BATTERY INDICATOR
The Remote Controlled Motion Sensing Alarm has
a low battery indicator light. When the batteries
need to be replaced, the indicator light will flash
slowly. Average battery life for typical usage is up
to one year.
LINKING
TO THE ALARM
Make sure you have installed the batteries before
proceeding.
1.
Remove
compartment cover and slide off the cover in
the direction of the open arrow. Locate the
LEARN button.
2.
Press the LEARN button.
3.
Immediately point the remote control towards
the front of the the alarm unit and press the
ARM button. The alarm will sound a single short
battery in the Remote Control:
THE REMOTE CONTROL
the
screw
from
the
battery
Advertisement
