Testing The System - Response SL3 Installation And Operating Manual

TESTING THE SYSTEM

The Control Panel has a built in test facility to
enable you to test the system at any time. However
it is recommended that the system is tested at
regular intervals not exceeding 3 months.
With the system in Standby
,
Press 1 2
User Access Code
The Arm and Part-Arm LEDs will flash
The system is now in Test Mode.
Note: After completing all required test functions
press to exit Test Mode and return to Standby.
ESC
DETECTOR WALK TEST
Before commencing testing please ensure that
there is no movement in any PIR protected area, all
doors/windows protected by Door / Window
Detectors are closed and that all battery covers are
correctly fitted.
An automatic time-out while in walk test will
automatically exit the test if no signal is received from
any linked device in a 10 minutes period. Each time a
valid signal is received the 10 minutes time-out period
will be reset.
Note: It may be helpful to have a 2nd person to
assist with this test.
1
Press
ENTER
Zone 1 LED will illuminate.
If your system includes Remote Controls:
For each Remote Control:
1. Activate the Panic/PA switch on the side of the
Remote Control or
The Control Panel will beep. All Zone, Fire and
Tamper LEDs will flash.
2. Press on the Remote Control:
The Control Panel will beep and the ARM LED
will flash.
24
,
3 4
ENTER
3. Press on the Remote Control:
The Control Panel will beep and the PART-ARM
LED will flash.
4. Press on the Remote Control:
The Control Panel will beep and the ARM and
PART-ARM LED's will flash.
If your system includes PIR Detectors:
For each Detector:
5. Ensure that the area protected by the PIR has
been free from movement for at least 3 minutes
and then walk into the area to trigger the detector.
The Control Panel will beep and the appropriate
zone LED that the detector is configured on will
flash.
Note: To conserve power the PIR will only
detect movement if there has been no movement
detected within the previous 3 minutes.
6. Remove the battery cover from the detector to
operate the anti-tamper switch.
The Control Panel will beep and the TAMPER
LED will flash.
7. Replace the detector's battery cover.
If your system includes Door / Window Detectors:
For each Detector:
8. Open the protected door/window to trigger the
detector.
The Control Panel will beep and the appropriate
zone LED that the detector is configured on will
flash.
9. Remove the battery cover from the detector to
operate the anti-tamper switch.
The Control Panel will beep and the TAMPER
LED will flash.
10. Replace the detector's battery cover.
Press to exit Detector Test.
ESC