Spectra Lighting Receiver; Linking The Control Panel To The Spectra Lighting Receiver; Spectra Lighting Test - Response SL3 Installation And Operating Manual

8
10. Now press and
Mode ON.
The siren will produce two short beeps followed
1 second later by a single long beep. The Siren
LEDs will flash together in conjunction with
the beeps.
11. Fit the keyhole slots in the top of the siren over
these screws and check that they form a neat fit
with minimal movement. If necessary remove
the siren and adjust the screws as required.
12. Remove the siren and fit the wall mounting plate
in position using the two 25mm fixing screws.
13. Fit the siren to the wall ensuring that the keyhole
slots are correctly fitted over the heads of the
two top fixing screws and the lower fixing hole
lines up with the wall plate.
14. Secure the Siren in place by fitting the lower
fixing screw in the wall plate. Do not over-tighten
the screw as this could damage the thread.
!
9
15. Press and
operate in normal Operating Mode.
16. Press to exit Test Mode and return to
ESC
Standby (Operating Mode).
IMPORTANT: Ensure that the rear tamper
switch is closed when you fit the siren to the
wall (i.e. listen for the switch to click). If the
switch does not close it will prevent the Siren
from operating correctly. If necessary,
remove the siren cover again and insert a
spacer between the tamper switch plunger
and the wall to ensure the switch closes
when the Siren is secured in position.
IMPORTANT:
The Siren must now be left in
position for at least 24 hours to fully
charge the Main Battery before
testing or operating the alarm.
22
to switch Service
ENTER
again to allow the Siren to
ENTER
SPECTRA LIGHTING
RECEIVER
LINKING THE CONTROL PANEL TO

SPECTRA LIGHTING RECEIVER

1. Place the Control Panel into Test Mode.
,
Press
?
User Access Code
2. Place the Spectra Receiver into Learn Mode by
pressing and holding the 'Learn' button on the
module for 3s.
3. Send the ID codes from the panel to the Spectra
Receiver...
Press 5
ENTER
Zone 1 LED will flash for 5 seconds while the
codes are transmitted.
After 3 seconds a "lights on for 10s" signal will be
transmitted by the control panel to the Spectra
receiver to learn the panel's code into memory.
The Receiver will automatically exit Learn mode.

SPECTRA LIGHTING TEST

1. Press 6
ENTER
The linked Spectra lighting will be activated for
5 seconds.
Zone 5 LED will be illuminated during the test.
2. Press to exit Test Mode.
ESC
,
? ? ?
ENTER