Table of Contents
Advertisement
CONTROL UNIT
INDICATORS AND KEYPAD
Access Code
Keypad
Buttons 0-9
INDICATOR LIGHTS
GREEN
On
Flashing
Off
RED
On
Slow flashing
Rapid flashing
Off
YELLOW
Slow Flashing
Rapid Flashing
On
Off
GREEN
On
Flashing
Off
IMPORTANT: THE CONTROL UNIT INDICATOR LIGHTS HAVE NO RELATION
TO THE PUSH BUTTONS THEY ARE ADJACENT TO.
CLEARING WARNING INDICATORS
The RED Alarm Activated and YELLOW Low Battery Indicators are cleared by entering
on the Control Unit. (See page 6 for Setting your Access Code).
LOCATION
When choosing a suitable location for the Control Unit,
the following points should be considered.
1. Ensure that the Control Unit is within a protected area
with the system Armed, ie: an intruder cannot reach
the Control Unit without opening a protected door or
being detected by a movement detector.
2. The position selected must be within reach of a 13A
socket.
Protector P500S
1
3
2
4
5
6
7
8
9
0
System Fully Armed
System Part Armed
Disarmed
Instant/Full Armed Zone Activated
Delay/Part Armed Zone Activated
Tamper/Personal Attack Zone Activated
Normal
Detector Low Battery
Low Battery in Test Mode
Test Mode On
Normal
Adaptor Power (Normal)
Back-up Battery Power Only
System Off
3. The Control Unit should be close to the entry/exit
door but not visible from the door or windows.
4. Do not locate the Control Unit closer than 1 metre to
any large metallic object eg: mirrors, radiators, fridge-
freezers, etc.
5. Locate the Control Unit in an easily accessible
position, between 1.5 and 2 metres above floor level
and in a position where it will be seen each day.
Part Arm Button
Full Arm Button
Disarm Button
Test Button
Indicator Lights
?
?
?
?
Access Code
3
Advertisement
Table of Contents
