Maintenance - Response SL3 Installation And Operating Manual

MAINTENANCE

Your Alarm System requires very little maintenance.
However, a few simple tasks will ensure its continued
reliability and operation.
SOLAR SIREN
1. It is recommended that the solar panel on the
top of the siren housing should be cleaned at
least twice a year, preferably in the Spring and
Autumn, using a soft damp cloth. Do not use
abrasive, solvent based or aerosol cleaners.
Do not attempt to clean inside the unit or allow
water to enter the unit.
This will ensure that the solar panel does not
become affected by the build up of excessive
dirt and receives all the available light.
2. The Siren should not be left for long periods with
the batteries connected, unless the unit is able
to receive sufficient light to maintain the battery
charge. Failure to maintain charge to the unit
will result in the rechargeable battery running
unacceptably low. Should this occur, the unit
must be recharged from a 7.5Vdc/100mA supply
(e.g. from a mains adaptor power supply). When
re-powering the Siren, fit a new 9V PP3 leak-
proof Alkaline power-up battery to ensure that
the Siren receives sufficient power until the solar
panel can recharge the main battery.
3. The main rechargeable battery has a typical life
of 3 - 4 years and needs no maintenance during
this period, provided the battery is kept charged.
The battery will be damaged if it is stored in a
discharged state for long periods.
IMPORTANT: Before removing the Siren from
the wall ensure that the Siren is first switched into
Service Mode to prevent the Tamper switch
operating and triggering an alarm, (see page 30).
The Siren must be switched back into Operating
Mode, otherwise the system cannot be Armed.
CONTROL PANEL
The rechargeable batteries have a typical life in
excess of 3 to 4 years and need no maintenance
during this period, provided they are kept charged.
The batteries will be damaged if they are stored in
a discharged state for long periods.
DETECTORS, REMOTE CONTROL
AND KEYPAD
The Detectors, Remote Control and Keypad require very
little maintenance. The batteries should be replaced
once a year or when a low battery status is indicated.
BATTERIES
Note: Before removing the battery cover on any
device to replace the battery ensure that the system
is switched into Test Mode to avoid triggering an alarm.
The specifications for replacement batteries are
as follows:
Remote Control:
1 x 3V CR2032 Lithium Cell (or equivalent)
Door / Window Detector:
2 x 3V CR2032 Lithium Cells (or equivalent)
PIR Movement Detector:
1 x 9V PP3 Alkaline Battery
Keypad:
1 x 9V PP3 Alkaline Battery
Note: Rechargeable batteries should NOT be fitted.
DISPOSAL AND RECYCLING
Directive (2002/96/EC)
This product is classified by the Waste Electrical or
Electronic Equipment (WEEE) Directive. It should
not be disposed of with other household or
commercial waste.
The Rechargeable Batteries contain Sulphuric Acid
– DO NOT ATTEMPT TO OPEN THE CASING.
At the end of its useful life the packaging and product
should be disposed of via a suitable recycling centre.
For information on available facilities, please contact
your local authority or the retailer from where the
product was purchased.
33