Table of Contents
Advertisement
single long beep/LED flash followed immediately
by two short beeps/LED flashes to indicate that it
has switched into Service Mode.
Operating Mode: Press and hold the
on the Remote Control.
fter approximately 6 seconds the Siren will
produce a single long beep/LED flash to indicate
that it has switched into Operating Mode.
External Connections
The Control Panel incorporates a terminal block for
connection of an external Hard-wired Siren or
Telephone Dialler Unit. The connection terminal block is
located inside the Control Panel behind the front cover.
To access the terminal block, press
?
?
,
User Access Code
This puts the system into Test Mode and prevents an
alarm occurring. Undo the two fixing screws on the top
edge of the Control Panel and open the front cover.
Before making any connections, ensure that the
memory jumper link P1 is in the 'OFF' position and
then remove the DC power jack and disconnect the
back-up batteries.
Switched
12Vdc output for
external Siren
(300mA max.)
Permanent
12Vdc power
supply output
(100mA max.)
Switching
relay contacts
(Volt-free)
Not used
Tamper circuit
connections
for wired Siren
Note: Jumper link P51 should be fitted into the ON
position only if the tamper circuit for a hardwired siren
is used, otherwise it must be in the OFF position.
fter making your external connections reconnect the
power supply and back-up battery. Then close the
?
?
,
GND
Hardwired
Siren
OUT
V+
GND
N.O.
C
Terminal
N.C.
Block Detail
GND
B+
GND
TAMP
Normally closed
tamper contact
Control Panel cover and tighten the fixing screws on
the top edge of the Control Panel.
Press
ESC
button
Testing the System
Initial Testing
s the system is initially installed it is recommended
that each device is tested in turn as it is installed, (refer
to testing instructions for particular device).
Testing an Installed System
The Control Panel has a programmed test routine.
You may test the system at any time, however it is
recommended that the system is tested at regular
intervals not exceeding 3 months.
With the system in Standby Mode with the Power
LED ON.
Press
The rm and Part- rm LEDs will flash.
The system is now in Test Mode
Note:
fter completing all required test functions press
to leave Test mode and return to Standby.
ESC
Detector Test
Before commencing testing please ensure that there
is no movement in any PIR protected area for at least
2 minutes, all doors/windows protected by Magnetic
Contact Detectors are closed and that all battery
covers are correctly fitted.
1
Press
Zone LED 1 will illuminate.
Trigger each Detector on the system by either walking
into a PIR Detector protected area or by opening a door/
window protected by a Magnetic Contact Detector.
each Detector is triggered the Control Panel will beep
and the LED of the zone which the Detector is set for
will be illuminated. The Tamper switches of devices
may also be tested in the same way in which case the
Tamper LED on the Control Panel will be illuminated.
Press
ESC
17
to leave Test mode and return to Standby.
?
?
?
,
User Access Code
to exit Detector test.
?
,
s
Advertisement
Table of Contents
