Testing The System; Testing An Installed System - Response SA1 E Installation And Operating Instructions Manual

Testing the System

Testing an Installed System

The system should be tested at regular intervals (at least
every 3 months) to ensure that it is operating correctly.
1. Before commencing testing please ensure the
following:
− The Siren is in Operating Mode and Disarmed
− There is no movement or people/pets in any
PIR protected area
− ll doors/windows protected by Magnetic
Contact Detectors are closed
− ll battery covers and housings are correctly
fitted
Remote Control:
2. Press the button on the Remote Control.
The Siren will beep once.
3. ctivate the P switch on the Remote Control
by sliding it upward.
The alarm will sound.
4. Stop the alarm by pressing the
on the Remote Control.
The Siren will stop and acknowledge the signal
by beeping twice (unless Beep Disable has
been selected).
If your system includes a Remote Keypad:
5. rm the system at the Remote Keypad by entering
your User ccess Code followed by the 'INST NT-
RM' button.
? ? ?
User Access Code
6. Press and hold both 'DEL Y- RM' buttons on
the Remote Keypad for approx. 3 seconds,
and
2
1
7. Stop the alarm and Disarm the system by
entering your User ccess Code followed by the
DIS RM button on the Remote Keypad.
? ? ?
User Access Code
button
?
,
the alarm will sound.
?
,
If your system includes PIR Detectors:
8. rm the system in Instant- rm mode by pressing
on the Remote Control.
The Siren will acknowledge the signal by beeping
once, (unless Beep Disable has been selected).
9. Ensure that the area protected by the PIR has
been free from movement for at least 2 minutes
and then walk into the area to trigger the
detector.
Note: To conserve power the PIR will only
detect movement if there has been no
movement detected within the previous 2
minutes.
10. Stop the alarm and Disarm the system by
pressing
The Siren will stop and acknowledge the signal by
beeping twice, (unless Beep Disable has been
selected).
11. Continue to test all PIR Detectors in turn as
described above (steps 8 - 10).
If your system includes Magnetic
Contact Detectors:
12. rm the system in Instant- rm mode by pressing
the button on the Remote Control.
13. Open a door/window protected by a Magnetic
Contact Detector and ensure that the alarm
sounds.
14. Disarm the system and stop the Siren by pressing
the button on the Remote Control.
15. Test each Magnetic Contact Detector in turn as
described above (steps 12 - 14.
18
on the Remote Control.