Testing The System - Response SL2 Installation & Operating Manual

TESTING THE SYSTEM

The system should be tested at regular intervals (at
least every 3 months), to ensure that it is operating
correctly.
1. Before commencing testing please ensure the
following:
– The Siren is in Operating Mode and Disarmed.
– There is no movement or people / pets in any
PIR protected area.
– All doors / windows protected by Magnetic
Door / Window Detectors are closed.
– All battery covers and housings are
correctly fitted.
If your system includes a Remote Control:
2. Press the button on the Remote Control
The Siren will beep once.
3. Activate the PA switch on the Remote Control by
sliding it forward.
The alarm will sound.
4. Stop the alarm by pressing the
the Remote Control.
The Siren will stop and acknowledge the signal
by beeping 10 times, (unless Beep Disable has
been selected).
If your system includes a Keypad:
5. Arm the system at the Keypad by entering
your User Access Code followed by the
'INSTANT-ARM' button.
? ? ?
User Access Code
The Siren will beep once.
6. Press and hold both 'DELAY-ARM' buttons on
the Keypad for approximately 3 seconds.
and
2
1
The alarm will sound.
20
button on
,
?
.
7. Stop the alarm and Disarm the system by
entering your User Access Code followed by the
'DISARM' button on the Keypad.
? ? ?
User Access Code
If your system includes PIR Detectors:
8. Arm the system in Instant-Arm mode by pressing
the button on the Remote Control.
The Siren will acknowledge the signal by beeping
once, (unless Beep Disable has been selected).
9. Ensure that the area protected by the PIR has
been free from movement for at least 2 minutes
and then walk into the area to trigger the detector.
Note: To conserve power the PIR will only detect
movement if there has been no movement detected
within the previous 2 minutes.
10. Stop the alarm and Disarm the system by pressing
the button on the Remote Control.
The Siren will stop and acknowledge the signal by
beeping 10 times, (unless Beep Disable has been
selected).
11. Continue to test all PIR Detectors in turn as
described above, (steps 8 - 10).
If your system includes Door / Window Detectors:
12. Arm the system in Instant-Arm mode by pressing
the button on the Remote Control.
13. Open a door/window protected by a
Door / Window Detector and ensure that the
alarm sounds.
14. Disarm the system and stop the Siren by pressing
the button on the Remote Control.
15. Test each Door / Window Detector in turn as
described above, (steps 12 - 14).
,
?