Web: Viewing And Configuring Gvrp - HP ProCurve Series 2810 Management And Configuration Manual

GVRP
Introduction
3-16
Figure 3-10. Example of Listing Showing Dynamic VLANs
Converting a Dynamic VLAN to a Static VLAN. If a port on the switch
has joined a dynamic VLAN, you can use the following command to convert
that dynamic VLAN to a static VLAN:
Syntax: static <dynamic-vlan-id>
For example, to convert dynamic VLAN 333 (from the previous example) to a
static VLAN:
ProCurve(config)# static 333
When you convert a dynamic VLAN to a static VLAN, all ports on the switch
are assigned to the VLAN in Auto mode.

Web: Viewing and Configuring GVRP

To view, enable, disable, or reconfigure GVRP:
1. Click on the Configuration tab.
Click on VLAN Configuration and do the following:
2.
a. To enable or disable GVRP, click on GVRP Enabled.
b. To change the Unknown VLAN field for any port:
Click on GVRP Security and make the desired changes.
i.
ii. Click on Apply to save and implement your changes to the
Unknown VLAN fields.
For web-based Help on how to use the web browser interface screen, click on
the button provided on the web browser screen.
[?]
Dynamic VLANs
Learned from
Switch "A"
through Port 1