HP ProCurve Series 2810 Management And Configuration Manual page 180

Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
6-32
2. Configure the priorities for the DSCPs you want to use.
Figure 6-11. Assigning 802.1p Priorities to the Selected DSCPs
3. Assign the DSCP policies to the selected device IP addresses and display
the result.
Figure 6-12. The Completed Device-Priority/Codepoint Configuration
The switch will now apply the DSCP policies in figure 6-11 to IPv4 packets
received on the switch with the specified IP addresses (source or destination).
This means the switch will:
■ Overwrite the original DSCPs in the selected packets with the new DSCPs
specified in the above policies.
Assign the 802.1p priorities in the above policies to the appropriate
■
packets.
DSCP Policies
Configured in this step.