Download  Print this page

Using The Cli To Remove A Member From A Stack - HP ProCurve Series 2810 Management And Configuration Manual

Procurve series 2810 switches.
Hide thumbs

Advertisement

ProCurve Stack Management
Configuring Stack Management
Figure 7-33. Example of Command Sequence for Converting a Commander to a Member
N o t e
7-42
Syntax:
no stack name < stack name>
stack join < mac-address >
If you don't know the MAC address of the destination Commander, you can
use show stack all to identify it.
For example, suppose you have a switch operating as the Commander for a
temporary stack named "Test". When it is time to eliminate the temporary
"Test" stack and convert the switch into a member of an existing stack named
"Big_Waters", you would execute the following commands in the switch's CLI:

Using the CLI To Remove a Member from a Stack

You can remove a Member from a stack using the CLI of either the Commander
or the Member.
When you remove a Member from a stack, the Member's Auto Join parameter
is set to No.
Using the Commander CLI To Remove a Stack Member. This option
requires the switch number (SN) and the MAC address of the switch to
remove. (Because the Commander propagates its Manager password to all
stack members, knowing the Manager password is necessary only for gaining
access to the Commander.)
Syntax:
[no] stack member <switch-num> mac-address <mac-addr>
Eliminates the "Test" stack and converts
the Commander to a Candidate.
Helps you to identify the MAC address of the
Commander for the "Big_Waters" stack.
Adds the former "Test" Commander to the
"Big_Waters" stack.

Advertisement

Table of Contents

   Related Manuals for HP ProCurve Series 2810

This manual is also suitable for:

Procurve 2810-24gProcurve 2810-48g

Comments to this Manuals

Symbols: 0
Latest comments: