HP ProCurve Series 2810 Management And Configuration Manual page 179

no qos device-priority < ip-address >
Deletes the specified IP address as a QoS type.
show qos device-priority
Displays a listing of all QoS Device Priority types currently
in the running-config file.
For example, suppose you wanted to assign these DSCP policies to the packets
identified by the indicated IP addresses:
1. Determine whether the DSCPs already have priority assignments, which
could indicate use by existing applications. This is not a problem if the
configured priorities are acceptable for all applications using the same
DSCP. (Refer to the "Note On Changing a Priority Setting" on page 6-61.
Also, a DSCP must have a priority configured before you can assign any
QoS types to use it.)
Figure 6-10. Display the Current DSCP-Map Configuration
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Types To Configure QoS for Outbound Traffic
IP Address DSCP Policies
DSCP
10.28.31.1 000111
10.28.31.130 000101
10.28.31.100 000010
10.28.31.101 000010
Priority
7
5
1
1
The DSCPs for this
example have not yet
been assigned an
802.1p priority level.
6-31