Download  Print this page

Adding Or Editing Vlan Names - HP ProCurve Series 2810 Management And Configuration Manual

Procurve series 2810 switches.
Hide thumbs


Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)

Adding or Editing VLAN Names

Use this procedure to add a new VLAN or to edit the name of an existing VLAN.
From the Main Menu select:
2. Switch Configuration
8. VLAN Menu . . .
2. VLAN Names
If multiple VLANs are not yet configured you will see a screen similar to
figure 2-10:
Figure 2-10. The Default VLAN Names Screen
Press [A] (for Add). You will then be prompted for a new VLAN name and
802.1Q VLAN ID : 1
Name : _
Type in a VID (VLAN ID number). This can be any number from 2 to 4094
that is not already being used by another VLAN. (The switch reserves "1"
for the default VLAN.)
Remember that a VLAN must have the same VID in every switch in which
you configure that same VLAN. (GVRP dynamically extends VLANs with
correct VID numbering to other switches. See chapter 3, "GVRP".)
Press [v] to move the cursor to the Name line and type the VLAN name (up
to 12 characters, with no spaces) of a new VLAN that you want to add,
then press [Enter].
(Avoid these characters in VLAN names:
Press [S] (for Save). You will then see the VLAN Names screen with the
new VLAN listed.
Default VLAN
, and


Table of Contents

   Related Manuals for HP ProCurve Series 2810

This manual is also suitable for:

Procurve 2810-24gProcurve 2810-48g

Comments to this Manuals

Symbols: 0
Latest comments: