Read The Default Status Screen - Cisco GoQAM Installation And Operation Manual

Read the Default Status Screen

The Default Status screen provides status information such as the channel frequency
setting, RF level settings, modulation type, and the number of active alarms. The
default status screen displays after one of the following occurs:
The reset process is complete.

You press ENTER to complete a command.

The following is an example of the Default Status screen.
Reading the Default Status Screen
The following table describes the information displayed on the default status screen.
Display
CH1
285.00 MHz
50.0 dBmV
ITUB 64QAM
Alarm 0
4004834 Rev D
Function
Current RF Channel output selected. The CH
number corresponds to the channel number
Note: The GoQAM uses only CH1 and CH2.
Established RF frequency setting for the selected
RF modulator (91 MHz to
869 MHz)
Configured RF level setting (42 dBmV to 56
dBmV)
Selected modulation type. Values are:
ITUB 64 QAM

ITUB 256 QAM

DAVIC 256 QAM

DAVIC 16 QAM

DAVIC 64 QAM

Current number of active alarms

Read the Default Status Screen

83