Table of Contents
Advertisement
Read the Default Status Screen
The Default Status screen provides status information such as the channel frequency
setting, RF level settings, modulation type, and the number of active alarms. The
default status screen displays after one of the following occurs:
The reset process is complete.
You press ENTER to complete a command.
The following is an example of the Default Status screen.
Reading the Default Status Screen
The following table describes the information displayed on the default status screen.
Display
RF1
285.00 MHZ
50.0 dBmV
ITUB 256QAM
Alarm 0
78-717866-01 Rev D
Function
Current RF Channel output selected. The RF number corresponds to
the number of the RF OUT port on the back panel of the MQAM.
Established RF frequency setting for the selected RF modulator (91 to
869 MHz).
Configured RF level setting (42 to 56 dBmV).
Selected modulation type. Values are:
ITUB 64 QAM
ITUB 256 QAM
DAVIC 256 QAM
DAVIC 16 QAM
DAVIC 64 QAM
Current number of active alarms
Read the Default Status Screen
47
Advertisement
Table of Contents
Troubleshooting
