Cisco GoQAM Installation And Operation Manual page 56

Chapter 3 Provision the RF GoQAM
Field
Administrative State
MAC Address
Subnet Mask
Default Gateway
Ports
The following table lists the Ports field descriptions.
Field
Reserved TSID Range
Input Block 1 ASI 1 Clear
Transport Stream ID
Input Block 2 ASI 3 Clear
Transport Stream ID
Port to Hubs
RF Out Parameters
The following table lists the RF OUT port (1 – 2) field descriptions.
Note: Overlay technology uses only two of the RF OUT ports on the RF GoQAM.
Field
Modulation
Transport Stream ID
40
Description
Specifies whether the modulator is active within the system.
The values are:
Offline: Default

Online: Active

Displays the MAC address of the GoQAM
Displays the IP subnet mask assigned by the system
administrator
Displays the network default gateway assigned by the
system administrator
Description
Identifies the available range of Transport Stream IDs (TSIDs)
Identifies the Transport Stream ID for input block 1 at ASI 1
Identifies the Transport Stream ID for input block 2 at ASI 3
Allows you to specify which hub is associated to any selected
RF output port. The default is all hubs under the defined
headend
Description
Displays the modulation format of the individual carriers
The default is 64-QAM for ITU J.83 Annex B.
Displays the identifier of the transport stream ID for each RF
Out module
4004834 Rev D