Cisco GoQAM Installation And Operation Manual page 64

Chapter 3 Provision the RF GoQAM
6 Enter the required configuration information into the blank fields on the Basic
Parameters tab in the Set Up RF GOQAM window, then go to step 9.
Important: Be sure to associate the port with a hub by clicking the Port to Hubs
button to open the RF Output Port window.
From the QAM List, highlight an RF GoQAM in the list, select File > Open. The
7
Set Up RF GOQAM window opens with the Basic Parameters tab to the forefront
displaying the Basic Parameters configuration fields.
8 Enter or change the desired information in the Basic Parameters fields.
Important: Be sure to associate the port with a hub by clicking the Port to Hubs
button to open the RF Output Port window.
Notes:

See the Basic Parameters field descriptions, earlier in this section, for
descriptions of each field.

Refer to the Digital Network Control System Online Help for your system
release for more details about required DNCS procedures.
48 4004834 Rev D