Read The Default Status Screen - Cisco GoQAM Installation And Operation Manual

Read the Default Status Screen

The Default Status screen provides status information such as the channel frequency
setting, IF level settings, modulation type, and the number of active alarms for the
GoQAM unit. The IF GoQAM displays the default status screen after one of the
following occurs:
The reset process is complete.

You press ENTER to complete a command.

The following is an example of the Default Status screen.
IF1 44.00 MHz
ITUB
Reading the Default Status Screen
The following table describes the information displayed on the Default Status screen.
Display
IF1
44.00 MHz
30.00 dBmV
ITUB 64QAM
Alarm 0
4004834 Rev D
30.0 dBmV
64QAM Alarm 0
Function
Current IF Channel output selected. The IF number
corresponds to the channel number
Note: The GoQAM uses only IF1 and IF2.
Established IF frequency setting for the selected IF
modulator
Configured IF power level setting
Note: The range for IF power level is 27.00 dBmV
to 37.00 dBmV.
Selected modulation type. Values are:
ITUB 64 QAM

ITUB 256 QAM

DAVIC 256 QAM

DAVIC 16 QAM

DAVIC 64 QAM

Current number of active alarms

Read the Default Status Screen

107