Cisco GoQAM Installation And Operation Manual page 29

Modulator rf output and if output hardware
Table of Contents

Advertisement

Item
Component
6
Gigabit Ethernet port
7
DVB ASI INPUTS 1-4
8
DVB ASI LEDs
9
CRAFT PORT
10
10/100BaseT port
11
GND
Back Panel Indicator Lights
The following illustration and table show the back panel indicator lights.
Item
1
2
3
4
5
6
7
8
4004834 Rev D
Indicator Light
ACTIVE (green)
LINK (green)
DATA 1 (green)
DATA 2 (green)
DATA 3 (green)
DATA 4 (green)
LINK (yellow)
ACTIVE (green)
Description
Not used (disabled) in the Overlay solution
Female BNC, 75 Ω connector. Allows for the input of
MPEG-2 transport stream data at a maximum rate of 216
Mbps
Data LEDs 1 through 4 light when the DVB ASI Input
ports are receiving valid MPEG-2 transport stream packets
For Cisco diagnostic use only
Ethernet port shares data with DNCS Ethernet hub
Ground screw for grounding the GoQAM
Description
Not used (disabled) in the Overlay solution
Not used (disabled) in the Overlay solution
Lights when the DVB ASI Input 1 port is receiving
valid MPEG-2 transport stream (TS) packets
Lights when the DVB ASI Input 2 port is receiving
valid MPEG-2 TS packets
Lights when the DVB ASI Input 3 port is receiving
valid MPEG-2 TS packets
Lights when the DVB ASI Input 4 port is receiving
valid MPEG-2 TS packets
Lights when a valid 10/100BaseT Ethernet link
connection exists
Lights when data traffic is on the 10/100BaseT Ethernet
link
Back Panel Overview
13

Advertisement

Table of Contents
loading

Table of Contents