Cisco GoQAM Installation And Operation Manual page 101

Accessing the GoQAM Menus
You can access GoQAM menus and screens by pressing the FREQ, LEVEL, CW, and
OPTIONS keys on the front panel.
Pressing the LEVEL, OPTIONS, and RF SEL keys repeatedly scrolls through their
respective sequential menus.
The following sections in this chapter describe the functions associated with each
key:
FREQ - Adjust the Frequencies of a Selected Carrier

LEVEL

- Adjust the RF Output Level of a Selected Carrier
- Mute the RF Output of a Selected Carrier
CW - Change the Carrier Mode of a Selected Carrier

OPTIONS - Monitor GoQAM Setup Options

RF SEL – Change an RF Carrier Frequency

Note: See Front Panel Overview (on page 10) for detailed descriptions of these keys.
Navigating Within a Menu or Changing a Screen Value
The Up and Down arrow keys are used in conjunction with the other front panel
keys to increment or decrement the values of a selected parameter within a screen or
to scroll up and down through a set of selections.
Saving Changes to Configuration Settings
Pressing the Enter key saves changes to the configuration settings. You must also
press the Enter key to return to the default status screen. Changes to any settings are
saved into NVRAM. This memory is located on the digital board and is used to
restore settings in the event of a power reset of the device.
4004834 Rev D
Use the Front Panel Keys to Change Configuration Settings
85