Cisco GoQAM Installation And Operation Manual page 161

RF Module Code
Download Failure
Screen
Unable to Boot
Successfully
4004834 Rev D
Unable to TFTP RF Code

The following message appears if the GoQAM is
unable to download the RF module code
execution files for boot mode 1 or boot mode 2
from the TFTP server.
Unable to TFTP RF
Restarting...
The GoQAM then automatically reboots.
Unable to perform BootP (Boot Mode 1)

The following message appears if the GoQAM is
in boot mode 1 while unable to perform a
successful boot process (BootP).
Unable to perform BootP
Continuing Startup...
The GoQAM then starts the application program.
Unable to perform Bootp (Boot Mode 2)

The following message appears if the GoQAM is
in boot mode 2 while unable to obtain a
successful BootP.
Unable to perform BootP
Restarting...
The GoQAM then automatically reboots.
Troubleshooting Boot Screen Error Messages
Code
Check the

configuration
file.
Check for an

incorrect IP
address, boot
mode, or
DNCS
address.
Reinstall the

GoQAM
package on the
DNCS if all
GoQAMs have
this error
condition.
Check IP

connectivity.
 Contact Cisco
Services.
Verify that the

Ethernet port
is connected
and that the
MAC address
for the unit
matches the
MAC address
listing on the
DNCS.
Contact

SciCare
Broadband
Services.
145