Chapter 4 Provision The If Goqam - Cisco GoQAM Installation And Operation Manual

4004834 Rev D
4 Chapter 4
Provision the IF GoQAM
Introduction
This chapter provides examples and descriptions of the DNCS
graphical user interfaces (GUIs) used for provisioning (configuring) the
IF GoQAM in an Overlay environment. Provisioning the GoQAM
prepares the device so that the DNCS recognizes it and so that it
operates properly.
Important: Your system must be operating SR 2.4/SR 3.4 (or later) to
use a GoQAM on your system. You must also have the Overlay feature
enabled.
Note: See Technical Specifications (on page 149) for the technical
specifications of the IF GoQAM and consult your network wiring
diagram when you provision the GoQAM to ensure a proper allocation
of bandwidth.
For more information about the DNCS and operating the DNCS
software, refer to the Digital Network Control System Online Help for
your system release.
In This Chapter
 Understand the IF GoQAM GUIs ....................................................... 54

Understand the Set Up IF GoQAM GUI ............................................ 55
 Understand the Set Up UpConverter GUI ........................................ 63

Provision an IF GoQAM on the DNCS .............................................. 71
53