Cisco GoQAM Installation And Operation Manual page 110

Chapter 5 Operating the RF Modulator
Viewing the NP1 Software Revision Level
The NP1 software revision screen displays the revision level for the Input processor
in the GoQAM. To display the NP1 software revision screen, follow these steps.
1 Press OPTIONS until the NP1 Software Revision screen appears.
NP1 SW:
1.0.0
Notes:
 In the above example, App is the application code and Boot is the boot code.
 This revision number for the application code (1.0.0) and the boot code
(1.0.0), represented in the above example, contains the major release number,
minor release number, and the point release number.
Important! If an asterisk (*) appears after one of the code version numbers, this
indicates that the code version is a mismatch to the GoQAM software package
version.
2 Press ENTER to return to the default screen.
Viewing the NP2 Software Revision Level
The NP2 software revision screen displays the revision level for Output 1 processor
in the GoQAM. To display the NP2 software revision screen, follow these steps.
1 Press OPTIONS until the NP2 Software Revision screen appears.
NP2 SW:
1.0.0
Notes:

In the above example, App is the application code and Boot is the boot code.

This revision number for the application code (1.0.0) and the boot code
(1.0.0), represented in the above example, contains the major release number,
minor release number, and the point release number.
Important! If an asterisk (*) appears after one of the code version numbers, this
indicates that the code version is a mismatch to the GoQAM software package
version.
2 Press ENTER to return to the default screen.
94
App Boot
1.0.0
App Boot
1.0.0
4004834 Rev D