Table of Contents
Advertisement
Understand the Boot Process
When the GoQAM boots, the boot code version and release date appear.
If BOOTP completes successfully, the IP address boot screen appears.
Note: Although it is not a typical setting, if the GoQAM is set to run in a Standalone
mode (boot mode 0), the following Standalone mode boot screen appears instead of
the "Starting GoQAM" boot screen.
The IP address boot screen remains visible for approximately 2 seconds. If no errors
occur and no downloads are attempted, the boot code starts the application code and
the following screen appears.
Next, a screen similar to the following appears.
Then, the default status screen appears.
4004834 Rev D
103
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the GoQAM and is the answer not in the manual?
Questions and answers