Winding The Bobbin With The Machine Threaded; Winding The Bobbin Using The Vertical Spool Pin - Husqvarna Viking Designer topaz 25 User Manual

WINDING THE BOBBIN WITH
THE MACHINE THREADED
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The
bobbins.
®
2. Pull the thread from the needle under the presser foot and
the inside to the outside.
Note: When using an earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind several turns of thread on the
bobbin to get started.
4. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Hold the end of the
to start winding. Once the bobbin begins to wind, cut the
excess thread. When the bobbin is full it will stop rotating.
Release the foot control. Push the bobbin spindle back to
the left, remove the bobbin and cut off the thread on the
thread cutter.
WINDING THE BOBBIN USING
THE VERTICAL SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
bobbins.
®
2. Place the large spool cap and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
the inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Hold the end of the
to start winding. Once the bobbin begins to wind, cut the
excess thread. When the bobbin is full it will stop rotating.
Release the foot control. Push the bobbin spindle back to
the left, remove the bobbin and cut off the thread on the
thread cutter.
Note: When using an earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind several turns of thread clockwise
on the bobbin to get started.
18
®
A
B
®
C
D
C
D