Bobbin Winding With The Machine Threaded - Husqvarna Viking Freesia 415 User Manual

Bobbin winding with the machine threaded

Make sure that the presser foot is up and the needle is in the highest posi-
tion.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place your empty bobbin with the small mark
on the front of the machine.
2. Pull the thread from the needle under the presser foot and to the right over the
thread guide (c).
3. Start from above and wind a few turns of thread around the bobbin. Cut off the
thread on the thread cutter (d).
4. Bring the bobbin spindle down. Press the foot control. When the bobbin
winding is finished, the bobbin will stop automatically. Remove the bobbin,
cut off the thread and bring the bobbin spindle up.
Note! We do not recommend winding clear nylon or other stretchy threads
through the needle. Instead see "Bobbin winding - vertical spool pin".
Bobbin winding - vertical spool pin
1. Place an empty bobbin with the mark
front of the machine.
2. Place the large spool holder under the thread on the spool pin.
3. Bring the thread under the thread guide (a) and over thread guide (b), then
around thread guide (c) as illustrated.
4. From above wind a few turns of thread around the bobbin and into the
cutter.
5. Bring the bobbin spindle down. Press the foot control. When the bobbin
winding is finished, the bobbin will stop automatically. Remove the
bobbin, cut off the thread and bring the bobbin spindle up.
Instruction book Freesia 415, 425
outwards on the bobbin spindle
outwards on the bobbin spindle on the
11