Husqvarna Viking Designer topaz 25 User Manual page 47

Remove thread from under stitch plate and in
bobbin area
When this pop-up appears you need to clean the area under
Thread Cutter to cut properly. Close the pop-up message by
pressing the OK button.
Check upper thread
Your machine stops automatically if the top thread runs out
or breaks. Re-thread the top thread and close the pop-up
message by pressing the OK button.
Main motor overload
If you are sewing on very heavy fabric or if the machine is
blocked when sewing, the main motor can get overloaded.
The pop-up message will close when the main motor and
power supply is secure.
The stitch cannot be programmed
This message is shown if you try to program or add a
buttonhole, bartack, darning stitch or the sew-on-button
stitch to a program. All stitches in your sewing machine are
programmable except for these. Close the pop-up message by
pressing the OK button.
The stitch cannot be saved
This message is shown if you try to save a buttonhole,
bartack, darning stitch or the sew-on-button stitch to My
pressing the OK button.
Program too long to add more stitches
If you try to add more than 20 stitches or letters in the same
program this message is shown. Close the pop-up message by
pressing the OK button.
Note: If you add a FIX, STOP or a Selective Thread Cut to the
program these will each use one memory space in the program.
S M 45
EWING ODE