LOWER THE FEED TEETH
The feed teeth are lowered when you move the switch on the
front of the free arm to the right. Move the switch to the left
if you wish to raise the feed teeth. The feed teeth will raise
as you begin to sew. The feed teeth should be lowered when
sewing on buttons and for free motion sewing.
CHANGING THE PRESSER FOOT
Press the ON/OFF switch to "O".
1. Make sure the needle is in the highest position and the
presser foot is lifted. Pull the presser foot towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push back until the foot snaps into
place.
CHANGING THE NEEDLE
Press the ON/OFF switch to "O".
1. Loosen the screw in the needle clamp with the screwdriver.
2. Remove the needle.
you until it will go no further.
4. Use the screwdriver to tighten the screw properly.
S
U
21
ET
P