Sewing Buttonholes - Husqvarna Viking Designer topaz 25 User Manual

SEWING BUTTONHOLES

The buttonholes in your sewing machine are specially adjusted
for different kinds of fabric and garments. Learn about
different buttonholes and when to use them by studying the
stitch table in the overview chapter.
should be interfaced and/or stabilized where buttonholes are
to be sewn.
Perfectly Balanced Sensor One-Step Buttonhole
size of the button on the GraphicDisplay using the up and
down arrow buttons. When sewing, your sewing machine
size.
Note: The buttonhole size will vary with the thickness and style of your
1. Attach the
2. Plug the cord into the socket above the needle area.
3. Measure the button diameter using the button ruler on the
front of the machine.
4. Use the up and down arrow buttons to set the button size
0-50 mm.
by lifting it, which makes it easier to place the fabric under
the presser foot. Use the markings on the left toe of the
edge. Place the edge of the garment at the middle mark to
6. Before sewing, line up white area on the side of the red
wheel with the white marking line on the foot.
is sewn away from you stabilizing the left buttonhole
column, then the satin column is sewn toward you. This
is repeated for the right column. The bartacks are also
sewn automatically. The arrows on the GraphicDisplay
will show when each part of the buttonhole is sewn and in
what direction. Keep the foot control depressed until the
when the buttonhole is complete.
feature will select the
™
A
S T 53
EWING ECHNIQUES