Husqvarna Viking Designer topaz 25 User Manual page 40

STITCH DENSITY (3)
If you have selcted a buttonhole the GraphicDisplay will show
the density setting instead of the stitch length setting. You will
now be able to change the density setting by pressing the +
and – buttons.
GraphicDisplay will show the density setting for satin stitches.
Use the + and –
Note This is often used with specialty threads and when a less dense satin
stitch is desired.
NEEDLE POSITION (4)
If a straight stitch is selected the needle position is shown on
the GraphicDisplay instead of the stitch width. The + and –
29 positions.
MIRROR SIDE TO SIDE (5)
stitch side to side. If the button is pressed when straight stitch
with left needle position is selected, the needle position is
Out Mode for stitch programs, the whole stitch program is
mirrored. The change is visible on the GraphicDisplay and an
Note: If a stitch cannot be mirrored a beep will be heard when pressing
the Mirror Side to Side button.
38
3
A
B
Stitch density +
4
C
Stitch density –
5
C