Threading For Twin Needles; Winding The Bobbin With The Machine Threaded - Husqvarna Viking Sapphire 875 Quilt User Manual

Threading for twin needles

Press the ON/OFF switch to OFF.
1. Insert a twin needle.
2. Use a second thread spool or wind a bobbin with the thread
you are going to use as the second upper thread.
3. Lift the spool pin up and all the way to the right. Lock the
spool pin in the vertical position by slightly pressing it down.
Slide on the large spool cap. For spools smaller than the
medium size spool cap, place a felt pad under the thread
spool.
4. Place the rst thread spool on the spool pin. The spool
should rotate in a clockwise direction when the thread reels
off the spool.
5. Thread the machine as described on page 13.
LEFT NEEDLE:
Check to ensure that the thread lies between the left thread
tension discs (A). Thread the left needle manually.
6. Pull out the auxiliary spool pin and slide on the large spool
cap. For spools smaller than the medium size spool cap, place
a felt pad under the thread spool.
7. Place the second thread on the spool pin. The second spool
should rotate in a counterclockwise direction when the thread
reels off the spool.
8. RIGHT NEEDLE: Thread the machine as before but this thread
should lie between the right thread tension discs (A) and
outside the needle thread guide (B). Thread the right needle
manually.
Only use symmetrical twin needles (C). Do not
NOTE:
use this type of twin needle (D), since it may damage your
sewing machine.
Winding the bobbin with the
machine threaded
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only ts on one way, with the
logo facing up. Use only original HUSQVARNA VIKING®
bobbins.
2. Pull the thread from the needle under the presser foot and to
the right through the thread guide (C).
3. Guide the thread through the hole in the bobbin (D) from the
inside to the outside.
When using an earlier version of HUSQVARNA
NOTE:
VIKING® bobbins that do not have a hole, wind several
turns of thread on the bobbin to get started.
4. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Press the foot control to start
winding. Hold the end of the thread rmly when starting to
wind. Once the bobbin begins to wind, cut the excess thread.
When the bobbin is full, it will stop automatically. Push the
bobbin spindle back to the left, remove the bobbin and cut
off the thread on the thread cutter.
14
Getting ready to sew
A
D
C
B
C
D