Threading The Upper Thread; Bobbin Winding With The Machine Threaded - Husqvarna Viking Prelude 350 User Manual

Threading the Upper Thread

Make sure the presser foot is raised and the needle
is in the up position
1. Pull the spool pin out. Place the thread on the
spool pin and the spool holder on the spool
pin as described. Push the spool pin back in.
2. Bring the thread in the direction of the arrow
under the thread guide (a) and over the thread
guide (b).
3. Bring the thread down between the thread
tension discs.
4. Continue threading by drawing the thread from
the right into the slot on the take-up lever.
5. Thread last guide just above the needle.
6. The needle is threaded from front to back. The
white on the presser foot ankle makes it easy to
see the eye of the needle.
7. Place thread under the presser foot and into
the thread knife where it is cut.
Bobbin Winding with the
Machine Threaded
Make sure that the presser foot is up and the
needle is in the highest position.
Note! Do not use a plastic presser foot when
bobbin winding.
1. Place your empty bobbin with the small mark
outwards on the bobbin spindle on the
front of the machine. Bring the bobbin spindle
down.
2. Pull the thread from the needle under the
presser foot and to the right over the thread
guide (c).
3. Start from above and wind a few turns of
thread around the bobbin. Cut off the thread
on the thread knife (d).
4. Press the foot control. When the bobbin win-
ding is fi nished, remove the bobbin, cut off the
thread and bring the bobbin spindle up.
Procedures
4.
7.
6.
Note! We do not recommend winding specialty
threads such as clear nylon or other stretchy
threads through the needle. Instead see "Bobbin
winding – vertical spool pin".
2.
a
b
3.
5.
c
1.
d
7