Embroidery Pop-Up Messages - Husqvarna Viking Designer topaz 25 User Manual

EMBROIDERY POP-UP MESSAGES

Embroidery unit calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine area for
calibrating the embroidery arm. You will also be reminded to
snap on the R foot for embroidery. Press the OK button to
calibrate.
Note: It is very important to remove the hoop, otherwise the hoop or the
embroidery unit may be damaged while calibrating.
Embroidery unit not supported. Please replace
embroidery unit.
You can only use the type of embroidery unit that is delivered
with your machine. Attach the correct embroidery unit.
Attach correct hoop
When the size of the hoop on the machine does not match
the size displayed on the GraphicDisplay, your machine will
not sew. Change the hoop to the size displayed or change the
setting for hoop size to match your selected hoop, see page 72.
Check upper thread
Your machine stops automatically if the top thread runs out
or breaks. Re-thread the top thread and close the pop-up
button to continue.
Cut thread end
When starting to embroider or after changing the thread, the
machine will sew a few stitches and then stop so you can cut
the thread end.
Note: This function is cancelled if "Automatic Jump Stitch Trim" is
activated in the SET Menu, see page 32.
74