Connect The Embroidery Unit; Remove The Embroidery Unit; Attach The Embroidery Foot R - Husqvarna Viking Designer topaz 25 User Manual

CONNECT THE EMBROIDERY UNIT

embroidery unit onto the free arm of the machine until
adjusting feet so that the machine and embroidery unit are
even. If the machine is turned off, turn it on.
3. A pop-up message tells you to clear the embroidery
area and remove the hoop for calibration. Press OK.
The machine will calibrate and the embroidery arm will
move to the ready position. This calibration will set
your embroidery functions each time you slide on the
embroidery unit.
Note: DO NOT calibrate the machine with the embroidery hoop
attached as this can damage the needle, presser foot, hoop and/or the
embroidery unit. Be sure to clear all materials from around the machine
before calibrating so the embroidery arm does not bump into anything
while calibrating.

REMOVE THE EMBROIDERY UNIT

1. To store the embroidery unit, remove the hoop and
move the embroidery arm to Park Position by pressing
the Needle Up/Down button. You can also select Park
Position in the Hoop Options Menu. Press the Hoop
Options button to enter the menu.
Note: It is very important that the hoop is removed, otherwise the
hoop, needle or presser foot may be damaged.
2. Press the button at the left, underneath the embroidery

ATTACH THE EMBROIDERY FOOT R

for instructions on how to change presser foot.
Note: You can also use the optional Sensor Q-foot when embroidering
(part number 413192045). The machine needs to be set in Free Motion
Spring Action Mode when embroidering with the optional Sensor Q-foot,
see page 31.
A
B
E S U 63
MBROIDERY ET P