Function Buttons - Husqvarna Viking Designer topaz 25 User Manual

FUNCTION BUTTONS

(Embroidery Mode functions are in brackets)
1
7
8
9
1. START/STOP
Press this button to start or stop the machine sewing or
embroidering when you are not using the foot control. Press
Your machine stops automatically at color changes and when
2. STOP (MONOCHROME)
IN SEWING MODE:
just one unit of the stitch. Your sewing machine ties off the
thread and stops automatically when one stitch unit or stitch
program has been completed. The LED next to the button is
the stitch is completed. Press the button again if you wish to
activate it once more.
the same size.
Tip: If you want to repeat the STOP function for a stitch unit several
times in a row you can save the stitch with a STOP at the end in a
program (see programming, page 40).
IN EMBROIDERY MODE:
automatically activated and the machine stops at color changes.
3. FIX (BASTE)
IN SEWING MODE:
automatically activated when you select a stitch, use the
At the beginning, your machine sews a few tie-off stitches
and your machine sews a few tie-off stitches and stops
function can be programmed, see page 40.
26
2 3 4 5 6
Note: FIX Auto can be cancelled in the SET Menu (see page 31). No
automatic FIX stitches will be sewn unless you use the FIX button on
your machine.
IN EMBROIDERY MODE:
embroidery design area or to baste the fabric to the stabilizer.
4. SELECTIVE THREAD CUTTER
IN SEWING MODE:
and your machine ties off the threads, cuts the top and bobbin
threads, raises the presser foot and the needle, and activates the
sewing.
When the stitch or stitch program is
function can be programmed, see page 40.
Note: Your machine cuts the threads automatically after certain stitches
such as completing a Sensor One Step Buttonhole. Selective Thread
Cutter Auto can be cancelled in the SET Menu, see page 31.
IN EMBROIDERY MODE:
Cutter while embroidering it automatically cuts the top and
bobbin threads and raises the presser foot. At the end of a
color block only the top thread is cut. When the design is
Note: Selective Thread Cutter Auto can be cancelled in the SET Menu,
see page 31.
5. NEEDLE STOP UP/DOWN (TRIM POSITION)
IN SEWING MODE:
the needle up or down. The setting of the needle stop position
is changed at the same time. An arrow pointing up or down,
next to the needle on the GraphicDisplay indicates if Needle
You can also tap the foot control to raise or lower the needle.
If both the needle and the presser foot are in up position, only
the presser foot will be lowered when you tap the foot control
ly.