Threading The Upper Thread - Husqvarna Viking Designer topaz 25 User Manual

D
E

THREADING THE UPPER THREAD

Make sure the presser foot is raised and the needle is in the up
position
Press the ON/OFF switch to "O".
1. Place the thread on the spool pin and the spool cap on the
spool pin as described on page 14.
2. Spool pin in horizontal position:
Bring the thread over and behind the pre-tension thread
pool pin in vertical position:
S
Instead of bringing the thread into the pre-tension guide
3. Bring the thread down between the thread tension discs
A
C
B
4. Continue threading in the direction indicated by the
arrows. Bring the thread from the right into the slot on the
5. Take the thread down and behind the last guide just above
S U 15
ET P