Adjust Designs; Design Height - Husqvarna Viking Designer topaz 25 User Manual

ADJUST DESIGNS

There are many options to adjust your designs. Always adjust
before starting to stitch-out. The settings are shown on the
GraphicDisplay. If you change the numbers for width and
changes are also visible on the GraphicDisplay.

DESIGN HEIGHT (1)

You can increase or decrease the size of the design up to
20%. Increase or decrease the design height using the + and
– buttons below the setting displayed on the GraphicDisplay.
The design height is scaled 5% each time you press the button.
The stitch count remains the same.
DESIGN WIDTH (2)
You can increase or decrease the size of the design up to
20%. Increase or decrease the design width using the + and
– buttons below the setting displayed on the GraphicDisplay.
The design width is scaled 5% each time you press the button.
The stitch count remains the same.
Note: You can Resize the design in the Embroidery Software (sold
separately).
MOVING DESIGNS TO POSITION (3)
Place your design anywhere in the embroidery area using the
position icons on the GraphicDisplay show in millimeters how
much the design has been moved vertically and horizontally
from its original center position.
ROTATE (4)
You can rotate the design around its center point. Each
90 degrees clockwise. To the right of the rotate icon on the
GraphicDisplay you can see how many degrees the design has
rotated from its original position.
Note: Some designs are too large to rotate 90 degrees. Each press of the
button will then rotate the design 180 degrees.
MIRROR SIDE TO SIDE (5)
design side to side. An icon is shown on the GraphicDisplay
1 2
Embroidery Mode, Stitch-out view
3
C
A
B
4
5
E M 71
MBROIDERY ODE