Winding The Bobbin With The Machine Threaded; Winding The Bobbin Using The Vertical Spool Pin - Husqvarna Viking Opal 670 User Manual

WINDING THE BOBBIN WITH
THE MACHINE THREADED
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fi ts on one way, with
the logo facing up. Use only original HUSQVARNA
VIKING ® bobbins.
2. Pull the thread from the needle under the presser foot and
to the right through the thread guide (C).
3. Guide the thread through the hole in the bobbin (D) from
the inside to the outside.
Note: When using an earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind several turns of thread on the
bobbin to get started.
4. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay/TouchScreen. Hold the
end of the thread fi rmly when starting to wind. Press the
foot control to start winding. Once the bobbin begins to
wind, cut the excess thread. When the bobbin is full it will
stop rotating. Push the bobbin spindle back to the left,
remove the bobbin and cut off the thread on the thread
cutter.
WINDING THE BOBBIN USING
THE VERTICAL SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fi ts on one way, with
the logo facing up. Use only original HUSQVARNA
VIKING ® bobbins.
2. Place the large spool cap and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B),
then through thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from
the inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay/TouchScreen. Hold the
end of the thread fi rmly when starting to wind. Press the
foot control to start winding. Once the bobbin begins to
wind, cut the excess thread. When the bobbin is full it will
stop rotating. Push the bobbin spindle back to the left,
remove the bobbin and cut off the thread on the thread
cutter.
Note: When using an earlier version of HUSQVARNA VIKING
bobbins that do not have a hole, wind several turns of thread clockwise
on the bobbin to get started.
18 – Getting Ready to Sew
®
A
B
®
C
D
C
D