Threading The Upper Thread - Husqvarna Viking Scandinavia 400 User Manual

Threading the upper thread

!
Turn off the main switch.
Make sure the presser foot is raised
and the needle is in the up po si tion.
1. Pull the spool pin out. Place the
thread on the spool pin and the
spool holder on the spool pin as
described. Push the spool pin back
in.
2. Bring the thread in the direction of
the arrow under the thread guide
(a) and over the thread guide (b).
3. Bring the thread down between the
thread tension discs.
4. Continue threading by drawing the
thread from the right into the slot
on the take-up lever.
5. Thread last guide just above needle.
6. The needle is threaded from front
to back. The white on the presser
foot ankle makes it easy to see the
eye of the needle.
7. Place thread under the presser foot
and into the thread cutter where it
is cut.
Upper thread warning
If the upper thread breaks or if thread
spool runs out, the machine stops
and gives a signal. The symbol
is ashing on the display. If thread
breaks: Re-thread the machine. The
symbol goes out. If thread spool
runs out: Remove your work and
the bobbin. Re-thread the machine.
Replace the bobbin and restart.
Learn your Scandinavia 400
4
b
7
3
5
6
2
1
a
9