Threading The Upper Thread - Husqvarna Viking Designer SE User Manual

Auxiliary Spool Pin
The auxiliary spool pin is used when winding a
bobbin from a second spool of thread or for a
second spool when sewing with a twin needle.
Pull the auxiliary spool pin towards you and
down. The slight downward angle is to allow
the thread to reel off evenly in a straight
direction to the thread guide.
For large thread spools, place a large spool
holder in front of the spool. For narrow thread
spools, place a small holder in front of the
spool. Extra spool holders are provided with the
accessories.

Threading the Upper Thread

When threading the upper thread, make sure
that the presser foot is raised and the needle is
in the up position.
Horizontal Spool Pin
1. Pull the spool pin out. Place the spool on
the spool pin with thread reeling off over the
top. Push the spool pin back in. Place spool
holder in front of the spool with fl at side
against spool. Hold the thread near the spool
using your right hand.
2. Use your left hand to bring the end of the
thread over and behind the pre-tension
thread guide (a) and under the thread guide
(b). Bring the thread over the thread tension
discs (c).
3. Continue threading in the direction indicated
by the arrows. Bring the thread from the
right when threading into the slot on the
take-up lever.
4. Take the thread down to the last guide just
above the needle.
Vertical Spool Pin
1. Pull the spool pin out. Place the thread spool
on the spool pin (follow the instructions on
previous page).
2. Thread the machine according to the
instructions above with one exception.
Instead of bringing the thread into the pre-
tension guide, bring it directly under the
thread guide (b).
Set it Up
c
3.
4.
b
a
b
2.
1.
1-11