Threading The Upper Thread 2:5 - Husqvarna Viking Viking Topaz 40 User Manual

D
E
THREADING THE UPPER THREAD
Make sure the presser foot is raised and the needle is in the up
position.
1. Place the thread on the spool pin and the spool cap on the
spool pin as described on page 2:4.
2. Spool pin in horizontal position:
Bring the thread over and behind the pre-tension thread
guide (A) and under the thread guide (B).
pool pin in vertical position:
S
Instead of bringing the thread into the pre-tension guide
(A), bring it directly under the thread guide (B).
3. Bring the thread down between the thread tension discs
(C).
A
C
B
4. Continue threading in the direction indicated by the
arrows. Bring the thread from the right into the slot on the
take-up lever (D).
5. Take the thread down and behind the last guide just above
the needle (E).
S U 2:5
et p